WHITE WASHABLE PAINT FOR BATHROOM AND KITCHEN KRAFT COMFORT BATHROOM AND KITCHEN / 8.5L

The surface to which it is to be applied must be solid, dry, clean, free from dust, grease, salts, rust, old, degraded paints or other impurities that may prevent adhesion.

• Degraded surfaces (showing cracks, cracks, holes, etc.) are repaired:
  • Cracks - with KRAFT Repair. After drying, the area is sanded, sanded and primed with KRAFT Wall Primer in the appropriate dilution or KRAFT Comfort Primer or, for dirty surfaces, KRAFT White Primer.
  • Cracks - repair with filler putty. After drying, sand the area and sand off. Finish with KRAFT Repair, sand again, then apply KRAFT Wall Primer in the appropriate dilution or KRAFT Comfort Primer or, for dirty surfaces, a coat of KRAFT White Primer.
• Previously painted, untreated surfaces - Wash with detergent solution (if necessary) and prime with KRAFT Wall Primer or KRAFT Comfort Primer or, for dirty surfaces, KRAFT White Primer. If the surfaces are load-bearing, with no peeling or blistering, proceed directly to the application of KRAFT Comfort Bathroom and Kitchen Paint.
• New cement or concrete surfaces should be primed, after a minimum of 30 days after installation, with KRAFT Wall Primer suitably diluted or KRAFT White Primer.
• Surfaces with patches of mould, fungus, algae: completely remove the mould layer and treat the surface with anti-mold solution. After 24 hours, clean with a clean brush and prime with KRAFT Wall Primer or KRAFT Comfort Primer or, for dirty surfaces, KRAFT White Primer diluted appropriately.
• Stained or smoke-stained surfaces should be primed with KRAFT Stain Blocker Aqua; after 24 hours the paint can be applied.
• For effective priming, test a small area of the surface for absorption. The applied primer must not form a glossy film after drying.