EXTERIOR AND INTERIOR WHITE KRAFT LIME BASED PAINT / 15L

Homogenise the product well before use.

Adjust the viscosity (dilution) for application by roller, brush/brush or spray:

The optimum application viscosity is different depending on the nature of the substrate, the type of tool used and the environmental conditions (temperature, humidity).

For application by roller, brush or brush under normal environmental conditions, the product is ready to use and generally does not require dilution. If the working environment is at high temperature and low humidity, the product can be diluted with a maximum of 10% potable water.

For application by spraying, the optimum viscosity for the machine used can be obtained by dilution with up to 10% potable water.

Application instructions

• The product is applied in 2 or more coats on the properly prepared surface.
• Recoating time (drying between coats): minimum 5 hours, depending on temperature.
• Drying time increases with decreasing temperature and increasing humidity.
• Environmental conditions: temperature: 10 - 25 °C; relative humidity < 65%.
• Optimum application conditions for the substrate: temperature 10 - 25°C and max. humidity 10%.

The product is applied intensively, evenly, with a brush or suitable brush, ideally with a natural bristle brush (without plastic). The paint is applied in cross strokes in a maximum length of 30 cm. Very coarse/rough surfaces, e.g. splatter plaster, should be spray painted. In the case of efflorescence from the substrate, wait 12 hours for recoating as during this time the paint develops its full covering capacity.

The product can also be applied by rolling with a trowel.

Instructions after use

Clean tools with water immediately after use. Spray nozzles must be cleaned when work is interrupted for more than 10 minutes to prevent clogging.

TDS PRODUCT DATA SHEETS

SDS SAFETY DATA SHEETS